RomBOOT
Start AT91Bootstrap...
Init DDR... Done!
Loading 1-Wire info...
Enumerate all roms:
Done, 0x0 1-wire chips found!

sn: 0x0;   rev: 0x0
Downloading image...
Done!


U-Boot 2013.01-dirty (Jan 16 2013 - 15:54:53)

CPU: AT91SAM9G25
Crystal frequency:       12 MHz
CPU clock        :      400 MHz
Master clock     :  133.333 MHz
DRAM:  128 MiB
WARNING: Caches not enabled
NAND:  No NAND device found!!!
atmel_nand: Fail to initialize #0 chip0 MiB
MMC:   mci: 0
mci: setting clock 260416 Hz, block size 512
mci: setting clock 260416 Hz, block size 512
mci: setting clock 260416 Hz, block size 512
mci: setting clock 260416 Hz, block size 512
mci: setting clock 22222222 Hz, block size 512
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   macb0
Warning: failed to set MAC address

Hit any key to stop autoboot:  0 
mci: setting clock 260416 Hz, block size 512
mci: setting clock 22222222 Hz, block size 512
mci: setting clock 260416 Hz, block size 512
mci: setting clock 260416 Hz, block size 512
mci: setting clock 22222222 Hz, block size 512
SD/MMC found on device 0
reading uEnv.txt
858 bytes read in 3 ms (279.3 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...
reading zImage
1775016 bytes read in 184 ms (9.2 MiB/s)
reading /dtbs/ariag25.dtb
12293 bytes read in 6 ms (2 MiB/s)
Booting from mmc ...
## Flattened Device Tree blob at 27ff0000
   Booting using the fdt blob at 0x27ff0000
   Using Device Tree in place at 27ff0000, end 27ff6004

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
[    0.000000] Booting Linux on physical CPU 0x0
.....